• <10E9 ohm resistance
  Meets the minimum recommended worksurface requirement of ANSI/ESD S20.20
• Reversible extruded homogenous vinyl
  Use as worksurface or floor mat
• Smooth surface on one side
  Easy to clean and maintain
• Non-glare finish on one side
  Easier to identify small parts
• Easy to cut
  Configure to fit your requirements
• Top of Mat kits laser engraved with ESD protective symbol and manufacturer
  Identifies ESD protective product for control and auditing purposes
• Dimensionally stable
  Will not shrink or curl
• Material thicknesses of 0.060”
  The thinner 0.060" material is the economical choice, and is ideal for use on cafeteria-style trays.
• Also available in thickness of 0.100"
  The 0.100" thick is a better value, providing a longer life and is ideal for general purpose worksurface matting. 
• Excellent color stability
  Will not discolor
• Lead-free RoHS compliant
• Grounding Hardware not included
• Made in America

Per ESD Association: "The most important functional consideration for worksurfaces is the RTG resistance from the top of the surface to the groundable point." ANSI/ESD S20.20 Table 1 recommends a requirement of less than 1 x 10E9 ohms. "If Charged Device Model damage is a concern then setting a lower resistance limit should be considered. Typically, 1 x 10E6 ohms." "Durability factors that should be considered are hardness, abrasion resistance, tear resistance, etc. Worksurfaces may require special heat resistant materials. Light reflection may be an important ergonomic consideration." (Ref: TR 20.20 section 5.3.1).